Raider 2WD V6-3.7L (2008)
Oil Pressure Sensor: Service and Repair
SENSOR/SWITCH-OIL PRESSURE
REMOVAL
1. Disconnect the negative cable from the battery.
2. Raise vehicle on hoist.
3. Remove front splash shield.
4. Disconnect oil pressure switch connector (4).
5. Remove the pressure switch (2).
INSTALLATION
1. Install the oil pressure switch.
2. Connect oil pressure switch connector.
3. Install front splash shield.
4. Lower vehicle.
5. Connect the negative battery cable.
6. Start the engine and ensure there are no oil leaks from the oil pressure switch.
