Raider 2WD V6-3.7L (2008)
Crankshaft Position Sensor: Service and Repair
SENSOR - CRANKSHAFT POSITION
REMOVAL 3.7L V-6
The Crankshaft Position (CKP) sensor (2) is mounted into the right rear side of the cylinder block. It is positioned and bolted into a machined hole.
1. Raise vehicle.
2. Disconnect sensor electrical connector.
3. Remove sensor mounting bolt (1).
4. Carefully twist sensor from cylinder block.
5. Check condition of sensor O-ring (3).
INSTALLATION 3.7L V-6
1. Clean out machined hole in engine block.
2. Apply a small amount of engine oil to sensor O-ring (3).
3. Install sensor (2) into engine block with a slight rocking and twisting action.
