Raider 2WD V6-3.7L (2008)
Camshaft Position Sensor: Description and Operation
SENSOR - CAMSHAFT POSITION
DESCRIPTION
The Camshaft Position Sensor (CMP) is bolted to the right-front side of the right cylinder head.
OPERATION [3.7L]
The Camshaft Position Sensor (CMP) sensor (3) contains a hall effect device referred to as a sync signal generator. A rotating target wheel
(tonewheel) for the CMP is located (4) at the front of the camshaft for the right cylinder head (2). This sync signal generator detects notches (1)
located on a tonewheel. As the tonewheel rotates, the notches pass through the sync signal generator. The signal from the CMP sensor is used in
conjunction with the Crankshaft Position Sensor (CKP) to differentiate between fuel injection and spark events. It is also used to synchronize the fuel
injectors with their respective cylinders. When the leading edge of the tonewheel notch enters the tip of the CMP, the interruption of magnetic field
causes the voltage to switch high, resulting in a sync signal of approximately 5 volts.
When the trailing edge of the tonewheel notch leaves then tip of the CMP, the change of the magnetic field causes the sync signal voltage to switch
low to 0 volts.
OEPRATION [4.7L]
