Raider 2WD V6-3.7L (2008)
9. Raise the vehicle on a hoist.
10. Remove the nut (2) securing the cable (1) to the starter solenoid (3).
11. Disconnect the battery cable retaining pushpin (6) securing the cable to the engine block.
12. Lower the vehicle.
13. Remove the battery positive cable from the vehicle.
INSTALLATION
NEGATIVE
1. Position the battery negative cable (4) in the vehicle and into the engine harness conduit.
2. One at a time, install the battery cable retaining pushpins (5), fasteners and routing clips until the cable is secure in the vehicle.
3. Install the bolt (2) securing the negative cable eyelet (3) to the left front fender. Tighten the bolt to 20 Nm (15 ft. lbs.).
