Raider 2WD V6-3.7L (2008)
28. Mount a dial indicator to the assembly, push down on the clutch discs, pull up on the reaction plate to ensure the plate is properly seated and zero
the indicator against the reverse clutch discs (2). Apply 20 psi of air pressure to the reverse clutch and record the dial indicator reading. Measure
and record Reverse clutch pack measurement in four (4) places, 90° apart. Take average of four measurements and compare with Reverse clutch
pack clearance specification. The correct clutch clearance is 0.81-1.24 mm (0.032-0.049 in.). Adjust as necessary. Install the chosen snap-ring and
re-measure to verify selection.
NOTE: The 545RFE uses one of three (3) different selective snap rings. They are identified by the end cuts (either straight [square] cut or
"butterfly" [S-curved] cut):
SELECTABLE END PLAY SNAP RINGS
^
One Square End, One Buttery Fly End = 1.55 mm (0.061 in.)
^
Both Ends Square Cut = 1.85 mm (0.073 in)
^
Both Ends Buttery Fly Cut = 2.2 mm (0.087 in.)
