Raider 2WD V6-3.7L (2008)
8. Remove any steering column (1) trim necessary to access the gearshift cable (2) and BTSI mechanism.
9. Disconnect the BTSI wiring connector (5).
10. Disconnect cable at lower column bracket and shift lever pin and pull the cable through the dash panel opening into the vehicle.
11. Remove gearshift cable (2) from vehicle.
INSTALLATION
1. Route the transmission end of the gearshift cable (1) through the opening in the dash panel.
2. Seat the cable grommet (2) into the dash panel opening.
