Raider 2WD V6-3.7L SOHC (2007)
Seat Belt Height Adjuster: Service and Repair
ADJUSTER - SEAT BELT TURNING LOOP
REMOVAL
WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat
belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is
cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or inoperative buckle
or retractor.
Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is
integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or faulty
seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mitsubishi Parts Catalog.
NOTE: A seat belt turning loop adjuster is used for both front outboard seating positions on all models; however, the following procedure applies only
to the B-pillar mounted adjuster used on double cab models. The telescoping roof rail mounted adjuster used on extended cab models is integral to the
front out- board seat belt and retractor assembly.
1. Unsnap the upper edge of the trim cover (1) from the front seat belt turning loop (2) and disengage the tab (3) on the lower edge of the cover to
access the turning loop screw.
