Raider 4WD V6-3.7L SOHC (2007)
1. Reach under the front seat cushion to position the seat track position sensor (4) to the open end of the bracket (1) located on the inboard side of
either the inner or outer, driver or passenger seat track (5).
2. Push the sensor firmly into the bracket until the snap feature (2) locks into place.
3. Reconnect the seat wire harness connector (3) to the sensor connector receptacle located on the end of the sensor. Be certain that the latch on the
connector is fully engaged.
4. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
5. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool. Refer to the appropriate diagnostic procedures.
