Raider 4WD V6-3.7L SOHC (2007)
5. Remove the caliper slide pin bolts (2).
6. Remove the disc brake caliper (1) from the caliper adapter (2).
7. Remove the caliper slide pins from the adapter.
INSTALLATION
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only Non-Petroleum based grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807 grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).