Raider 4WD V6-3.7L SOHC (2007)
4. Working in 1/2 turn increments, tighten the bearing cap retaining bolts starting with the middle cap working outward as shown.
5. Torque the camshaft bearing cap retaining bolts to 11 Nm (100 in. lbs.).
6. Position the camshaft drive gear into the timing chain aligning the V6 mark between the two marked chain links (Two links marked during
removal).
7. Using Special Tool 8428 Camshaft Wrench, rotate the camshaft until the camshaft sprocket dowel is aligned with the slot in the camshaft sprocket.
Install the sprocket onto the camshaft.
CAUTION: Remove excess oil from camshaft sprocket bolt. Failure to do so can cause bolt over-torque resulting in bolt failure.
8. Remove excess oil from camshaft sprocket bolt, then install the camshaft sprocket retaining bolt and hand tighten.
9. Remove timing chain wedge Tool 8379.
10. Using Tool 6958 spanner wrench with adapter pins 8346, torque the camshaft sprocket retaining bolt to 122 Nm (90 ft. lbs.).
11. Install the camshaft position sensor.
12. Install the cylinder head cover.
