Raider 4WD V6-3.7L SOHC (2007)
2. Position the HVAC housing (2) into the passenger compartment with the mounting studs and the condensate drain tube in their proper locations in
the dash panel.
3. Loosely install the three nuts (1) that secure the HVAC housing to the engine compartment side of the dash panel.
4. Loosely install the two bolts (1) that secure the HVAC housing to the passenger compartment side of the dash panel.
5. Tighten the three nuts that secure the HVAC housing to the engine compartment side of the dash panel to 7 N.m (62 in. lbs.).
6. Tighten the two bolts that secure the HVAC housing to the passenger compartment side of the dash panel to 3 N.m (26 in. lbs.).
7. Install the instrument panel.
8. Remove the previously installed plugs or caps and connect the heater hoses to the heater core tubes.
9. Remove the previously installed plugs or caps and connect the A/C liquid line and the A/C accumulator to the A/C evaporator.
10. Reconnect the negative battery cable.
11. If the heater core is being replaced, flush the cooling system.
12. Refill the engine cooling system.
13. Evacuate the refrigerant system.
14. Charge the refrigerant system).
AIR INLET HOUSING
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
