Raider 4WD V6-3.7L SOHC (2007)
Cornering Lamp: Service and Repair
ILLUMINATION LAMP
BULB - A/C-HEAT CONTROL REMOVAL
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
NOTE: There may be minor variations in the locations of the bulb/bulb holder units on the back of the A/C-heater control as a result of various optional
A/ C-heater control units. However, the bulb types and service procedures are identical for all of these bulbs.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel (1) from the instrument panel.
3. Use a small thin-bladed screwdriver to rotate the bulb holder (3) counterclockwise about 30 degrees to unlock it from the keyed opening in the
front A/C-heater control (2) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.
BULB - EVIC CONTROL REMOVAL
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
NOTE: There are provisions for up to four bulb/bulb holder units on the Electronic Vehicle Information Center (EVIC) circuit board. The two outboard
bulbs illuminate the EVIC push buttons, while the two center bulbs illuminate the optional universal transmitter push buttons. Therefore, the center bulb
locations are only populated on vehicles equipped with the optional universal transmitter.
