Raider 4WD V6-3.7L SOHC (2007)
1. Reach through the window (3) behind the instrument panel glove box opening (1) to align the base of the bulb with the bulb holder on the glove
box lamp and switch (2).
2. Push the bulb straight into the bulb holder until the base is firmly seated.
3. Reinstall the glove box into the instrument panel.
4. Reconnect the battery negative cable.
LAMP/SWITCH INSTALLATION
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the glove box lamp and switch (3) to the mounting hole in the instrument panel (2).
2. Reconnect the wire harness connector (1) to the lamp and switch.
3. Feed the wire harness back through the switch mounting hole.
