Raider 4WD V6-3.7L SOHC (2007)
Fog/Driving Lamp Bulb: Service and Repair
FRONT FOG LAMP
BULB REMOVAL
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Disconnect and isolate the battery negative cable.
2. Reach under and behind the front fascia to access the front fog lamp housing (3) on the back of the front bumper support (4).
3. Disconnect the wire harness connector (1) from the fog lamp socket (2).
4. Firmly grasp the socket on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the socket and bulb straight out from the keyed opening in the housing.
6. Pull the base of the bulb straight out of the socket.
BULB INSTALLATION
CAUTION:
-
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp,
the socket or the lamp wiring.
-
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will
result.
