Raider 4WD V6-3.7L SOHC (2007)
1. If removed, install the A/C pressure transducer (8) onto the A/C liquid line (1).
2. Position the A/C liquid line into the engine compartment.
3. Remove the tape or plugs from the opened ends of the A/C liquid line and the condenser and evaporator ports.
4. Lubricate new O-ring seals with clean refrigerant oil and install them onto the liquid line spring-lock coupler fitting. Use only the specified O-ring
seals as they are made of a special material for the R- 134a system. Use only refrigerant oil of the type recommended for the A/C compressor in
the vehicle.
5. Connect the A/C liquid line to the evaporator inlet tube (3).
6. Install the secondary retaining clip (4) onto the spring-lock coupler that secures the A/C liquid line to the evaporator inlet tube.
7. Engage the A/C liquid line into the body retaining clips (5).
8. Lubricate a new O-ring seal with clean refrigerant oil and install it and a new gasket onto the liquid line fitting. Use only the specified O-ring seal
as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
9. Connect the A/C liquid line to the condenser outlet port (7).
10. Install the nut (6) that secures the A/C liquid line to the condenser outlet port. Tighten the nut to 20 N.m (15 ft. lbs.).
11. Install the air filter housing.
12. Connect the wire harness connector (2) to the A/ C pressure transducer.
13. Reconnect the negative battery cable.
14. Evacuate the refrigerant system.
15. Adjust the refrigerant oil level.
16. Charge the refrigerant system.
