Raider 4WD V6-3.7L SOHC (2007)
Catalytic Converter: Service and Repair
CONVERTER - CATALYTIC
REMOVAL - 3.7L/4.7L ENGINE
CAUTION: When servicing or replacing exhaust system components, disconnect the oxygen sensor connector(s). Allowing the exhaust to hang
by the oxygen sensor wires will damage the harness and/or sensor.
1. Raise and support the vehicle.
2. Saturate all exhaust bolts and nuts with Rust Penetrant. Allow 5 minutes for penetration.
3. Disconnect the oxygen senor electrical connectors.
4. Remove the catalytic converter-to-manifold bolts (5).
5. Remove the catalytic converter to the exhaust pipe clamp (1).
6. If present, grind tack weld.
7. Remove the catalytic converter. You may have to loosen up other sections of the exhaust system.
INSPECTION
Look at the stainless steel body of the converter, inspect for bulging or other distortion that could be a result of overheating. If the converter has a heat
shield attached make sure it is not bent or loose.
If you suspect internal damage to the catalyst, tapping the bottom of the catalyst with a rubber mallet may indicate a damaged core.
INSTALLATION - 3.7L/4.7L ENGINE
