Raider 4WD V6-3.7L SOHC (2007)
1. Install the input speed sensor (1) into the transmission case.
NOTE: Before installing the speed sensor bolt, it will be necessary to replenish the sealing patch on the bolt using Loctite 242 Lock & Seal
Adhesive or equivalent.
2. Install the bolt to hold the input speed sensor into the transmission case. Tighten the bolt to 9 Nm (80 in.lbs.).
3. Install the wiring connector onto the input speed sensor
4. Verify the transmission fluid level. Add fluid as necessary.
5. Lower vehicle.
Sensor - Output Speed
SENSOR - OUTPUT SPEED
REMOVAL
1. Raise vehicle.