Raider 4WD V6-3.7L SOHC (2007)
4. Carefully position the driver airbag (1) in the steering wheel (2). Be certain that the clockspring pigtail wires and the steering wheel wire harness in
the steering wheel hub area are not pinched between the driver airbag and the steering wheel armature.
5. From the underside of the steering wheel, install and tighten the two screws (3) that secure the driver airbag to the steering wheel armature.
Tighten the screws to 10 N.m (90 in. lbs.).
6. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
Air Bag - Passenger
REMOVAL
WARNING:
-
To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting any
steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure
to take the proper precautions could result in accidental airbag deployment.
-
To avoid personal injury or death, when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should be
worn. There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation to the skin
and eyes.
NOTE: The following procedure is for replacement of a faulty or damaged passenger airbag. If the airbag is faulty or damaged, but not deployed, review
the recommended procedures for handling non-deployed supplemental restraints. If the passenger airbag has been deployed, review the recommended
procedures for service after a supplemental restraint deployment before removing the airbag from the vehicle.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the defroster grille from the top of the instrument panel.
3. Remove the glove box from the instrument panel.
4. Reach up into the instrument panel between the upper glove box opening reinforcement (2) and the cross car beam (1) to access and remove the
two screws that secure the passenger airbag lower bracket to the instrument panel support structure.
5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the edges of the passenger airbag door away from the top of the instrument
