Raider 4WD V6-3.7L SOHC (2007)
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the scuff plate trim from the right or left front door opening sill (5).
3. Lift the floor carpet upward from the sill far enough to access the side impact sensor on the floor panel (4) below the right or left outboard front
seat adjuster riser.
4. Remove the two screws (2) that secure the side impact sensor (3) to the floor panel.
5. Disconnect the body wire harness connector (1) from the sensor connector receptacle.
6. Remove the sensor from the floor panel.
FRONT IMPACT SENSOR - INSTALLATION
WARNING:
-
To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting any
steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure
to take the proper precautions could result in accidental airbag deployment.
-
To avoid personal injury or death, never strike or drop the front impact sensor, as it can damage the impact sensor or affect its
calibration. The front impact sensor enables the system to deploy the front supplemental restraints. If an impact sensor is accidentally
dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result in
accidental, incomplete, or improper front supplemental restraint deployment.
