Raider 4WD V6-3.7L SOHC (2007)
1. Position the rear seat belt and retractor (2) to the inner C-pillar (1).
2. Engage the tab on the back of the retractor into the T-slot in the inner C-pillar.
3. Install and tighten the screw (3) that secures the retractor to the inner C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
4. Route the seat belt, lower anchor, latch plate (7) and turning loop (4) through the clearance holes in the lower C-pillar trim (3). Be certain that the
seat belt webbing between the retractor and the lower anchor is not twisted.
5. Position the seat belt lower anchor to the mounting hole near the base of the inner C-pillar (1).
6. Install and tighten the screw (8) that secures the lower anchor to the inner C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
7. Reinstall the lower trim onto the inside of the C- pillar.
8. Reinstall the upper trim (2) onto the inside of the C-pillar.
9. Position the seat belt turning loop to the mounting hole in the upper C-pillar.
10. Install and tighten the screw (6) that secures the seat belt turning loop to the C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
11. Engage the tab on the lower edge of the trim cover (5) in the slot below the screw in the turning loop. Then press the upper edge of the trim cover
over the top of the turning loop until it snaps into place.
REAR CENTER
WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat
belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is
