Raider 4WD V6-3.7L SOHC (2007)
1. Disengage the center or the left outboard occupant buckle unit (2) from the elastic loop on the back of the rear seat cushion (1) and push the buckle
back through the crevice between the cushion and the rear seat back.
2. Lift up the seat cushion into its stowed position against the seat back.
3. Remove the nut (3) that secures the buckle unit to the stud (4) on the rear floor panel (5) near the base of the cab back panel. The stud and nut that
secures the buckle also secures the inboard rear seat mounting bracket to the rear floor panel.
4. Remove the buckle from the stud and the inboard rear seat mounting bracket.
REAR CENTER ANCHOR & RIGHT OUTBOARD - DOUBLE CAB
WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat
belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is
cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or inoperative buckle
or retractor.
Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is
integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or faulty
seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mitsubishi Parts Catalog.
NOTE: The unique, keyed center seat belt lower anchor buckle and the right outboard occupant buckle are serviced as a unit with their anchor brackets.
These buckles are secured to the rear floor along with the right side of the rear center seat belt retractor mounting bracket by a common screw, but can be
removed from the mounting bracket and serviced separately from the seat belt and retractor.
