Raider 4WD V6-3.7L SOHC (2007)
13. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front seat cushion frame (3). Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
14. Install and tighten the screw (4) that secures the lower anchor to the seat. Tighten the screw to 39 N.m (29 ft. lbs.).
15. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
FRONT OUTBOARD - DOUBLE CAB
WARNING:
-
To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting any
steering wheel, steering column, airbag, occupant classification system, seat belt ten- sioner, impact sensor, or instrument panel
component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint
system. Failure to take the proper precautions could result in accidental airbag deployment.
-
To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is
cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or inoperative
buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the
unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component.
Always replace damaged or faulty seat belt and child restraint components with the correct, new and unused replacement parts listed in
the Mitsubishi Parts Catalog.
NOTE: The following procedure is for replacement of a faulty or damaged seat belt and retractor unit. The front retractor also includes a seat belt
tensioner. If the front seat belt or retractor is faulty or damaged, but the seat belt tensioner is not deployed, review the recommended procedures
for handling non-deployed supplemental restraints. If the seat belt tensioner has been deployed, review the recommended procedures for service
after a supple- mental restraint deployment before removing the unit from the vehicle.
