Raider 4WD V6-3.7L SOHC (2007)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
SENSOR - ENGINE COOLANT TEMPERATURE
REMOVAL - 3.7L ENGINE
The Engine Coolant Temperature (ECT) sensor (3) on the 3.7L engine is installed into a water jacket at front of intake manifold near rear of generator.
WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE INJURY BY SCALDING. COOLING SYSTEM MUST BE PARTIALLY
DRAINED BEFORE REMOVING THE COOLANT TEMPERATURE SENSOR.
1. Partially drain the cooling system.
2. Disconnect the electrical connector from the sensor (3).
3. Remove the sensor from the intake manifold.
INSTALLATION - 3.7L ENGINE