Raider 4WD V6-3.7L SOHC (2007)
Power Window Switch: Testing and Inspection
Switch - Window/Door Lock
SWITCH - WINDOW/DOOR LOCK
Refer to the appropriate wiring information. The Light-Emitting Diode (LED) illumination lamps for all of the window/lock switch window and lock
switches receive battery current through the circuit breaker in the Integrated Power Module (IPM). If only one LED in the switch is inoperative, replace
the switch. If the driver side front door window operates in a normal manner, but the Auto-Down feature is inoperative, replace the window/lock switch.
1. Disconnect and isolate the battery negative cable.
2. Remove the window/lock switch from the door trim panel.
3. Disconnect the door wire harness connectors from the switch.
Window/Door Lock Switch Test Part 1
Window/Door Lock Switch Test Part 2
4. Test the switch continuity. See the Switch Tests chart to determine if the continuity is correct for the suspect switches in each switch position. If
not OK, replace the window/lock switch as required.
