Raider 4WD V6-3.7L SOHC (2007)
Clutch Pedal Assembly: Service and Repair
CLUTCH PEDAL
REMOVAL
1. Remove retaining clip securing push rod (5) on clutch pedal (6).
2. Slide push rod off clutch pedal pin.
3. Remove snap ring and washer attaching clutch pedal to the pivot shaft.
4. Slide pedal off pivot shaft (1) and remove pedal.
5. Remove and inspect bushings in pedal bore. Replace bushings if worn or cracked.
INSTALLATION
1. Lubricate pedal bushings and shaft (1) with a silicone grease.
2. Install bushings in pedal bore and on pin.
3. Install pedal (6) on pivot shaft (1).
4. Secure pedal on shaft with washer and snap ring.