Raider 4WD V6-3.7L SOHC (2007)
Clutch Release Bearing: Service and Repair
CLUTCH RELEASE BEARING
REMOVAL
1. Remove transmission and transfer Case.
2. Disconnect release bearing (5) from fork (1) and remove bearing.
INSTALLATION
1. Inspect release bearing slide surface of transmission front bearing retainer (3). Replace retainer if slide surface is scored, worn or cracked.
2. Inspect release fork (1) and fork pivot (2) Be sure pivot is secure and in good condition. Be sure fork is not distorted or worn. Replace release fork
retainer spring if bent or damaged in any way.
3. Lightly lubricate pilot bearing (5), input shaft splines (4), bearing retainer slide surface (3), fork pivot (2) and release fork (1) pivot surface with
high temperature bearing grease.
4. Install release fork and bearing. Verify fork and bearing are properly secured.
5. Install transmission/transfer case.