Raider 4WD V6-3.7L SOHC (2007)
4. Clean shaft splines and apply a coat of multi-purpose grease.
5. Align master splines and slide front and rear half-shafts together.
6. Position slip yoke boot (1) on boot collar and install clamp (2).
7. Install propeller shaft in vehicle.
BEARING - CENTER ADJUSTMENTS
Launch shudder is a vibration that occurs at first acceleration from a stop. Shudder vibration usually peaks at the engines highest torque output.
Shudder is a symptom associated with vehicles using a two-piece propeller shaft. To decrease shudder, lower the center bearing in 3.0 mm (0.125 in.)
increments. Use shim stock or fabricated plates. Do not use washers. Replace the original bolts with the appropriate increased length bolts.
