200SX L4-1998cc 2.0L DOHC MFI (SR20DE) (1995)
2)
Insert a paper clip through the steam vent hole in the spark plug wire boots to insure the holes are clear (see Figure 1).
NOTE:
The steam vent hole allows water vapor to escape if water becomes trapped in the spark plug hole.
3)
Inspect spark plug wire boots for cracks, hardening or deformities that could prevent sealing between the boots and the camshaft
(valve) cover.
4)
Replace all spark plug wires if one or more of the boots show signs of cracks, hardening or deformities.
B.
If the spark plug holes are dry and the spark plug wire boots are in good condition, proceed with step 2.
2.
Inspect the entire surface of each spark plug wire tube for pin holes and/or cracks (see Figure 2)
A.
If one or more spark plug wire tubes have pin holes and/or cracks, replace all spark plug wires.
B.
If the spark plug wire tubes do not have cracks or pin holes, use the service manual to diagnose the DTCs.