nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 5274 > < Diagram Information and Instructions|Page 5272
Page 10
background image

The customer may indicate the incident goes away after the car warms up (wintertime). The cause could be related to water freezing somewhere in the
wiring/electrical system. There are two methods to check for this. The first is to arrange for the owner to leave his car overnight. Make sure it will get
cold enough to demonstrate his complaint. Leave the car parked outside overnight. In the morning, do a quick and thorough diagnosis of those electrical
components which could be affected. The second method is to put the suspect component into a freezer long enough for any water to freeze. Reinstall the
part into the car and check for the reoccurrence of the incident. If it occurs, repair or replace the component.

Water Intrusion

The incident may occur only during high humidity or in rainy/snowy weather. In such cases the incident could be caused by water intrusion on an
electrical part. This can be simulated by soaking the car or running it through a car wash.
Do not spray water directly on any electrical components.

Introduction

In general, testing electrical circuits is an easy task if approached logically. Before beginning, it is important to have all available information on the
system to be tested. Also, get a thorough understanding of system operation. Then you will be able to use the appropriate equipment and follow the
correct test procedure.

You may have to simulate vehicle vibrations while testing electrical components. Gently shake the wiring harness or electrical component to do this.

OPEN  A circuit is open when there is no continuity through a section of the circuit. 

SHORT  There are two types of shorts.

1. SHORT CIRCUIT When a circuit contacts another circuit and causes the normal resistance to change.
2. SHORT TO GROUND When a circuit contacts a ground source and grounds the circuit.

Testing For "OPENS" In the Circuit

Before you begin to diagnose and test the system, you should rough sketch a schematic of the system. This will help you to logically walk through the

Diagram Information and Instructions|Page 5274 > < Diagram Information and Instructions|Page 5272