200SX SE-R L4-1998cc 2.0L DOHC MFI (SR20DE) (1998)
e. Method A: Turn all bolts 90 to 95 degrees clockwise with Tool or suitable angle wrench.
Method B: If an angle wrench is not available, mark all cylinder head bolts on the side facing engine front. Then, turn each cylinder head bolt
90 to 95° clockwise.
f.
Turn all bolts another 90 to 95° clockwise.
g. Ensure that paint mark on each bolt faces the rear of the engine. (Method B only.)
Do not turn any bolt 180 to 190 degrees clockwise all at once.
Arrange bolts (Size and length).
(A): M6 x 53.8mm (2.12 inch)
(B): M6 x 37 mm (1.46 inch)
(C): M8 x 35 mm (1.38 inch)
(D): M6 x 64 mm (2.52 inch)
Tightening procedure
STEP 1:
RH camshaft
Tighten bolts (9) - (10) in that order, then tighten bolts (1) - (8) in numerical order: 2 Nm (0.2 kg-m, 17 inch lbs)
LH camshaft
Tighten bolts (11) - (12) in that order, then tighten bolts (1) - (10) in numerical order: 2 Nm (0.2 kgs.cm, 17 inch lbs)
STEP 2:
Tighten bolts in numerical order: 6 Nm (0.6 kgs.cm, 52 inch lbs)
STEP 3: