Nissan and Datsun Workshop Service and Repair Manuals

Clutch: Specifications
Low and Reverse Brake

DIMENSIONS

Driven Plate And Transmission Case Clearance:

Standard Value ........................................................................................................................................................  1.4 - 1.8 mm (0.055 - 0.071 inch)
Wear Limit ...................................................................................................................................................................................  2.8 mm (0.110 inch)

Thickness Of Drive Plate:

Standard Value ............................................................................................................................................................................  2.0 mm (0.079 inch)
Wear Limit ...................................................................................................................................................................................  1.8 mm (0.071 inch)

Thickness Of Retaining Plates Part No. and Thickness:

31667-31x10 ................................................................................................................................................................................  3.6 mm (0.142 inch)
31667-31x11 ................................................................................................................................................................................  3.8 mm (0.150 inch)
31667-31x12 ................................................................................................................................................................................  4.0 mm (0.157 inch)
31667-31x13 ................................................................................................................................................................................  4.2 mm (0.165 inch)
31667-31x14 ................................................................................................................................................................................  4.4 mm (0.173 inch)
31667-31x15 ................................................................................................................................................................................  4.6 mm (0.181 inch)

GENERAL

No. Of Drive Plates ..........................................................................................................................................................................................................  5
No. Of Driven Plates ........................................................................................................................................................................................................  5

TIGHTENING SPECIFICATIONS

Brake Band:

Anchor End Pin ..........................................................................................................................................................  3.9 - 5.9 Nm (35 - 52 inch lbs.)
Anchor Lock Nut .............................................................................................................................................................  31 - 36 Nm (23 - 27 ft. lbs.)
No. Of Turning Revolutions For Anchor End Pin ..................................................................................................................................  2.375 - 2.625