200SX SE L4-1597cc 1.6L DOHC MFI (GA16DE) (1997)
6. Press wheel hub into steering knuckle. Maximum load P: 29 kN (3 ton, 3.3 US ton)
CAUTION: Be careful not to damage grease seal.
7. Check bearing operation.
a. Add load P with press. Load P: 34.3 - 49.0 kN (3.5 - 5.0 ton, 3.9 - 5.5 US ton)
b. Spin steering knuckle several turns in both directions.
c. Make sure that wheel bearing operates smoothly.
INSTALLATION
1. Install steering knuckle with wheel hub.
2. Replace strut lower mounting nuts.
3. When installing steering knuckle to strut, apply oil to threaded portion of drive shaft and both sides of plain washer. Also, be sure to hold bolts
while tightening nuts. Torque to 114 - 133 Nm (84 - 98 ft. lbs.).
4. Tighten wheel bearing lock nut to 196 - 275 Nm (145 - 202 ft. lbs.).
5. Check wheel bearing axial end play. Axial end play: 0.05 mm (0.0020 inch) or less.