240SX L4-2.4L (KA24DE) (1993)
Rear Wheel Steering Oil Pump: Service and Repair
REPLACEMENT
1. Remove oil pump drive belt.
2. Drain fluid into a suitable container.
3. Disconnect and plug oil pipes.
4. Remove oil pump mounting bolts then the oil pump.
5. Reverse procedure to install, bleeding hydraulic system.
Fig. 6 Exploded View Of Oil Pump
DISASSEMBLE
Parts which can be disassembled are strictly limited.
Never disassemble parts other than those specified. Refer to Fig. 6 to disassemble the oil pump assembly, noting the following:
1. Remove inlet and outlet connectors. The discharge connector incorporates a flow control valve. Ensure care is taken not to drop connector.
2. Remove end cover assembly then the driveshaft snap ring and the driveshaft.
3. Remove front cover oil seal.