280ZX L6-2753cc 2.8L SOHC (L28E) (1982)
Technical Service Bulletin # TS85112
Date: 851121
Recall - Emissions/Ignition System modifications
TS85-112
November 21, 1985
Emission Control
SPECIAL SERVICE CAMPAIGN
1982 280ZX NON-TURBOCHARGED
VEHICLES REGISTERED IN CALIFORNIA
INTRODUCTION
This bulletin describes procedures for the replacement of the exhaust gas Sensor and the distributor vacuum controller on 1982 280ZX (S130)
Non-Turbocharged vehicles. This campaign will be limited to those vehicles which are presently registered in the state of California.
BACKGROUND
Nissan has determined that operating conditions have caused unexpected emission control deterioration. As a result, the exhaust gas sensor and
distributor vacuum controller should be replaced in order to reduce exhaust emissions on the 1982 280ZX non-turbo vehicles being operated in
California.
Nissan will notify all owners of the affected vehicles by letter. They will be asked to bring their vehicle to a Nissan dealer for free replacement of the
exhaust gas sensor and the distributor vacuum controller. A copy of the owner's letter is shown on page 5/5 of this bulletin.
Nissan has undertaken this Voluntary Service Campaign to assure that these vehicles do not emit pollutants in excess of California emission standards.
AFFECTED MODELS
All 1982 280ZX Non-Turoocharged vehicles which are presently registered in the State of California. This includes vehicles which were originally
registered in another state but are now registered in California. Vehicles presently registered in other states are not involved in this campaign.
DEALER RESPONSIBILITY
1.
The dealer is responsible for replacing the exhaust gas sensor and the distributor vacuum controller on each vehicle which falls within the range of
this campaign. This includes vehicles purchased from private parties, presented by transient California owners and vehicles on dealer used car lots.
2.
The dealer must install the underhood label (Figure 1) next to the existing Emission Control Information label when the correction has been
completed.
1982 280ZX (S130) EXHAUST GAS SENSOR & DISTRIBUTOR VACUUM CONTROLLER SERVICE CAMPAIGN
This vehicle has been modified as described in Nissan Technical Bulletin EC85-008 (TS85-112), NMC/USA.
NISSAN MOTOR CO., LTO.
FIGURE 1
PARTS INFORMATION
Each vehicle corrected will require one sensor and one vacuum controller. Dealers should order parts through the normal parts distribution system in
anticipation of their local demand.
DESCRIPTION
PART NUMBER
Exhaust Gas Sensor
2690-F5300
Vacuum Controller
22301-P7901
Service Procedure
1.
Replace the exhaust gas sensor with new sensor (Figure 2).
II. Replace the distributor vacuum controller using the following procedures: