300ZX V6-2960cc 3.0L SOHC MFI (VG30E) (1988)
*8.
Using a heat gun, heat the connector until the shrink tube (transparent part of the connector) conforms to the wire. Do no overheat the connector.
Tape each connector individually.
NOTE:
The injector harness has been wrapped in BLACK.
*9.
On the Maxima right bank only, form the harness in the "S" type configuration.
*10. On all models, tape the entire connection from sub-harness to the main harness. This creates a finished look and provides an additional moisture
barrier.