300ZX V6-2960cc 30L SOHC MFI (VG30E) (1988) Distributor Service Models W/ Crank Angle Sensor
/Page-819001.png)
Distributor: Service and Repair
Distributor Replace
REMOVAL
1.
Mark position of No. 1 tower of distributor cap on distributor housing.
2.
Remove distributor cap.
3.
Crank engine to align rotor with No. 1 mark on housing.
4.
Place a mark between distributor housing and engine.
5.
Remove distributor retaining bolt and the distributor. Do not crank engine when distributor is removed from engine.
INSTALLATION
1.
Align rotor with No. 1 mark on housing.
2.
If engine was cranked when distributor was removed from engine, crank engine until No. 1 cylinder is on compression stroke and the timing marks
align on the pulley and front cover.
3.
Install distributor into engine, aligning all index marks made during removal.
4.
Loosely install distributor retaining bolt.
5.
Adjust ignition timing and tighten distributor retaining bolt.
