300ZX 2+2 V6-2960cc DOHC (VG30DE) (1994)
^
Wrap a small screwdriver with vinyl tape and use it to insert the valves into proper position.
Pressure regulator valve
^
If pressure regulator plug is not centered properly, sleeve cannot be inserted into bore in upper body.
If this happens, use vinyl tape wrapped screwdriver to center sleeve until it can be inserted.
^
Turn sleeve slightly while installing.
Accumulator control plug
^
Align protrusion of accumulator control sleeve with notch in plug.
^
Align parallel pin groove in plug with parallel pin, and install accumulator control valve.
2. Install parallel pins and retainer plates.