nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Brakes - Judder/Pedal Feel/Noise Diagnosis/Repair|Page 4694 > < Brakes - ABS Sensor Precaution Using On Car Brake Lathe|Page 4688
Page 1
background image

Brake Drum: Technical Service Bulletins
Brakes - Judder/Pedal Feel/Noise Diagnosis/Repair

Classification: BR00-004d

Reference: NTB00-033d

Date: August 8, 2007

ALL NISSAN; BRAKE NOISE/JUDDER/PEDAL FEEL DIAGNOSIS AND REPAIR

This bulletin has been amended. The Applied Vehicles have been updated. Please discard all previous versions of this bulletin.

APPLIED VEHICLE(S): 
All Nissan

SERVICE INFORMATION

^

This bulletin is to assist you in responding to customer questions about brake operation, and provides diagnostic and repair information for each item
listed, if any should occur.

^

Most brake incidents fall into the following categories:

a.

Brake Noise: A squeak, squeal, clunk, or groan that occurs when the brakes are applied or released.

b.

Brake Judder: A vibration that can be felt in the vehicle, steering wheel or brake pedal when the brakes are applied.

c.

Pedal Feel: The effort needed to operate the brakes is too high or too low.

SERVICE PROCEDURE

1.

Verify the condition by road testing the vehicle with the customer.

2.

Determine the specific brake incident based on the description in the Service Information above.

3.

Follow the appropriate repair procedure(s), shown below, for your specific incident.

BRAKE NOISE

^

Brakes can make a range of noises when applied or released. Some noises are normal and no repair action should be taken.

^

Use the following descriptions to identify the specific type of brake noise and the appropriate repair:

Squeak noise when the brakes are cold:

^

Usually occurs during the first few stops in the morning.

^

This is a normal condition. No service action is necessary.

Squeak noise with the brakes at normal operating temperatures:

^

Refer to technical bulletins specific to the model of vehicle regarding this incident.

^

If there are no bulletins for the car you are working on, install OE type pads using the information listed under Brake Service shown in this
bulletin and the appropriate Service Manual procedures.

Notes about brake pads and brake noise:

Original Equipment (OE) brake pads are installed on all current Nissan vehicles at the factory.

^

The OE pads use a Non-asbestos Organic (NAO) compound. The NAO material provides state of the art resistance to squeal noise.

^

These pads are available as service parts and must be used if replacing brake pads under the terms of the Nissan new car warranty.

Key Value brake pads are also available as a high quality service replacement part at a very attractive price.

Brakes - Judder/Pedal Feel/Noise Diagnosis/Repair|Page 4694 > < Brakes - ABS Sensor Precaution Using On Car Brake Lathe|Page 4688