Front Door Window Regulator Removal and Replacement Guide
/Page-1928002.png)
1. Remove front door finisher.
2. Remove mounting bolts, and remove module assembly.
3. Disconnect harness connector for the module assembly, and unclip the harness from the back.
Installation
Install in the reverse order of removal.
Inspection after Removal
Check regulator assembly for the following items. If a malfunction is detected, replace or grease it.
-
Wire wear
-
Regulator deformation
-
Grease condition for each sliding part
The arrows in the figure show the application points of body grease.
Inspection after Installation
SETTING OF LIMIT SWITCH
If any of the following work has been done, set the limit switch (integrated in the motor).
-
Removal and installation of regulator.
-
Removal and installation of motor from regulator.
-
Operate the regulators as a unit.
-
Removal and installation of the glass.
Resetting
After installing each component to the vehicle, follow the steps.
1. With the door open, lift up and hold the power window switch until the door glass is fully closed.
2. Get inside the vehicle and close the door.
-
You need to close the door so the door switch is fully depressed.
3. Press and hold the reset switch. While holding the reset switch, press down and hold the power window switch until the door glass is fully opened.
