370Z V6-3.7L (VQ37VHR) (2010)
a. Remove rear cover plate and set the ring gear stopper [SST:
KV10118600 (J-48641)] (A) as shown in the figure.
b. Loosen crankshaft pulley bolt and rotate bolt seating surface at
10 mm (0.39 in) from its original position.
1 : Crankshaft pulley
CAUTION:
Never remove crankshaft pulley bolt because it is used as a supporting point for suitable puller.
c. Place suitable puller tab on holes of crankshaft pulley, and pull crankshaft pulley through.
CAUTION:
Never put suitable puller tab on crankshaft pulley periphery, because this damages internal damper.
28. Remove oil pan (lower). See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan (Lower)/Exploded View.