810 Maxima L6-2793cc 2.8L DSL SOHC (LD28) (1982)
Corrective Action
Type II
Replace the propeller shaft with a modified propeller shaft assembly. The center bearing insulator can be replaced independently if the modified
propeller shaft is not available. (If only the insulator is replaced, the propeller shaft unbalance may increase after overhaul. Therefore, it may then be
necessary to rebalance the propeller shaft.)
NOTE:
Do not use a modified center bearing insulator on a Maxima Wagon, as there may be interference between the propeller shaft joint and the
center brake cable bracket, under certain driving conditions.
If a modified propeller shaft on the new center bearing insulator is not available, use the following procedure.
^Install shims in the center bearing insulator until the vibration is acceptable. (See Fig. 2).
Part Number
Part Name
Thickness
37518-N8200
Spacer Ctr. Brg. Mtg.
= 1mm
37518-N8201
Spacer Ctr. Brg. Mtg.
= 2mm (std.)
37518-N8202
Spacer Ctr. Brg. Mtg.
= 4mm
37518-N8203
Spacer Ctr. Brg. Mtg.
= 6mm
37518-N8204
Spacer Ctr. Brg. Mtg.
= 8mm
Vary the shim thickness until vibration is eliminated, but do not exceed 8mm thickness.
Part Information
Part Number
Part Name
Former
New
Model
Remarks
Kit-Center bearing
37521-Q0125
37521-W1025
910
with insulator
37000-W1500
37000-W1501
1981 All Models,
1982 M/T
Propeller Shaft
37000-F5100
37000-F5101
1981.5 & 1982
30mm shorter
Assembly
Diesel A/T
than W1501
37000-F5200
37000-F5201
1982 Gasoline
30mm shorter
A/T
than W1501
Warranty Information
CS
PNC
CT
Operation No.