Altima L4-2.5L (QR25DE) Hybrid (2007)
10.
Torque the 12 mm nut to:
16 Nm (1.6 kg-m, 11 ft-lb)*
^
Use special tool J-49063 and a torque wrench.
*NOTE:
The above torque values have already been adjusted to compensate for the length of the J-49063 tool when used with a torque wrench of 11 to
15 inches in length.
Install the Exhaust Manifold/Catalytic Converter Heat Shield
(Only for vehicles with more than 800 miles on the odometer.)
1.
Remove the 3 mounting screws.
^
Discard the old screws, do not reuse.
2.
Remove the old heat shield / lower cover and install the new one.
^
Use new screws included in the Heat Shield Kit listed in the Parts Information.
^
Torque the new screws to 5.8 Nm (0.59 kg-m, 51 in-lb).