Altima L4-2.5L (QR25DE) Hybrid (2007)
-
A: Locked position
-
B: Unlocked position
1. Lift up and swing the connector lock lever (1) to unlock the connector.
2. Pull up on the engine room harness connector (2) to disconnect it from the inverter (3).
16. Remove the engine room harness clip from the bracket and set the engine room harness aside.
17. Disconnect the EGI harness connector (3) from the inverter (2).
-
<=: Front
18. Remove the inverter nuts.
19. Remove the inverter from the vehicle.
20. Remove any necessary brackets from the inverter.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
-
When installing the inverter, lower RH bracket, lower LH bracket, rear LH bracket, rear RH bracket and upper LH bracket should be attached to
the inverter in advance.
-
When lower RH bracket, lower LH bracket, rear LH bracket, rear RH bracket and upper LH bracket are attached to the inverter, they should be
touched to anti-rotation at the boss of the inverter.
-
When tightening bolts, perform the following procedure.
-
Temporarily tighten the bolts A, B, E, F.
-
Connect MG1 harness connector and MG2 harness connector.
-
Fully tighten the bolts H, K.
-
Fully tighten the bolts G, I, J and L.
-
Fully tighten the bolt F.
-
Fully tighten the bolts A, B, C, D, E.