Altima L4-2.5L (QR25DE) Hybrid (2007)
7. Remove support bearing bolts using power tool, and pry drive shaft from transaxle.
^
Pry off drive shaft from transaxle.
INSPECTION AFTER REMOVAL
^
Move joint up/down, left/right, and in axial direction.Check for any rough movement or significant looseness.
^
Check boot for cracks or other damage, and for grease leakage.
^
If damaged, disassemble drive shaft to verify damage, and repair or replace as necessary.
INSTALLATION
Installation is in the reverse order of removal. Note the following:
^
Refer to FAX-10, "Removal and Installation (Right Side)" for tightening torque. Install in the reverse order of removal.
CAUTION:
Do not reuse non-reusable parts.
^
In order to prevent damage to differential side oil seal, place Tool "A" onto oil seal before inserting drive shaft as shown. Slide drive shaft into
slide joint and tap with a hammer to install securely.
Tool number: KV38106800 (J-34297)
^
Install new circlip on drive shaft in the circular clip groove on transaxle side.
CAUTION:
Make sure the new circlip on the drive shaft is securely fastened.
^
After its insertion, try to pull the flange out of the slide joint by hand. If it pulls out, the circlip is not properly meshed with the transaxle side gear.