Altima V6-3.5L (VQ35) (2003)
/Page-542015.png)
16. Install the front oil seal on the front timing chain case using a suitable tool. Apply clean engine oil to the oil seal edges.
^
Install it so that each seal lip is oriented as shown.
Suitable drift
Outer diameter: 59 mm (2.32 inch)
Inner diameter: 49 mm (1.93 inch)
CAUTION: Press fit straight and avoid causing burrs or tilting the oil seal.
^
Using a suitable drift, press-fit oil seal until it becomes flush with timing chain case end face.
^
Make sure the garter spring in the oil seal is in position and seal lip is not inverted.
17. Apply Silicone RTV Sealant to front timing chain case.
^
Use Genuine Silicone RTV Sealant, or equivalent.
^
Before installation, wipe off the protruding sealant.
18. Install the rear case pin into dowel pin hole on front timing chain case.
19. Tighten bolts to the specified torque in order shown in the figure.
