Altima V6-3.5L (VQ35) (2003)
24.
Select the ECM program to install (see Figure 16).
25.
The "REPROGRAM START" window should appear (see Figure 17).
NOTE:
If you get an error message, refer to the ECU Reprogramming Software Operations Manual.
CAUTION DURING REPROGRAMMING:
^
Do not unplug CONSULT-II from the vehicle during reprogramming. Permanent ECM damage can occur.
^
Do not open any door or the trunk during reprogramming.
^
On some vehicles, the cooling fans may come on during reprogramming. This is a normal condition. Do not disconnect the cooling fans.
Forgetting to reconnect them may cause severe engine damage. A vehicle battery charger is needed* to maintain the battery voltage level during
reprogramming.
* You should have hooked up a battery charger in Section 1