Altima V6-3.5L (VQ35) (2003)
b.
Install the original radius rod mounting pins to the new suspension member and tighten the nuts to: 120 - 140 Nm (12.2 - 14.3 kg-m, 88.5 -
103.3 ft-lb). See Figure B6.
c.
Re-install the original suspension component assemblies onto the new suspension member in the reverse order of removal. Make note of the
following:
NOTE:
Do NOT torque any of the nuts/bolts yet. You'll do this later using a special A-arm adjustment tool # J-47438.
^
The upper control arm bolts are installed from inboard to outboard as shown in Figure B7.
^
There are two eccentric Bolts for the inner end of the front lower links and the inner end of the rear lower links. They are installed as shown in