Altima V6-3.5L (VQ35) (2003)
c.
Use the stabilizer bar mounting nuts as shown in Figure B9b to hold the tool in place.
d.
Tighten the suspension components nuts/bolts to the highlighted (shaded) torque specifications at this time (see Figure B10). You'll tighten
the remaining bolts/nuts later.
Use a backup wrench when tightening fasteners that use a nut and a bolt.
8.
Be sure to remove the A-arm adjustment tool after the nuts/bolts are torqued.
9.
Perform the above procedure on the passenger (RH) side of the rear suspension member.
10.
Install the rear suspension member assembly by performing Procedure D.
C - Replace/Seal Front Bushings In Rear Suspension Member and Seal
PROCEDURE C: Replace / Seal Front Bushings in Rear Suspension Member and Seal ONLY Rear Bushings in Suspension Member
To perform this procedure, you will need: