Altima V6-3.5L (VQ35) (2003)
6. Loosen lower ball joint tightening nut.
7. Separate knuckle from lower ball joint stud with Tool.
8. Remove knuckle from transverse link.
INSPECTION AFTER REMOVAL
Wheel Hub
^
Check wheel hub for cracks by a magnetic exploration or dying test, and replace if cracked.
Knuckle
^
Check for deformity, cracks (by magnetic exploration or dying test) and damage on steering knuckle, replace if necessary.
Snap Ring
^
Check for wear and damage on snap ring, replace if necessary.
INSTALLATION
^
To install, reverse the removal procedure.
Disassembly and Assembly
DISASSEMBLY
CAUTION:
^
When removing wheel hub or wheel bearing from knuckle, replace wheel bearing assembly (outer race, inner races and grease seals) with a new
one.
^
When replacing wheel bearing, replace complete wheel bearing assembly (inner races and outer rail).
1. Press out wheel hub from knuckle with a suitable tool.
2. Remove snap rings.
3. Press out wheel bearing from knuckle.
ASSEMBLY