Altima V6-3.5L (VQ35) (2003)
2.
Remove the transmission control cable from the slotted transmission control arm (see Figure 1).
3.
Shift the slotted transmission control arm (see Figures 1 and 2) into Neutral (N) position.
4.
Check the adjustment of the Park/Neutral Switch by inserting a 4 mm (5/32") dowel pin into the adjustment holes of the transmission control arm
and Park/Neutral Switch (see Figure 2).
Use the "chuck end" of a 4 mm (5/32) drill bit if a dowel pin is not available.
5.
It the 4 mm (5/32") dowel pin cannot be inserted, adjust the Park/Neutral Switch as follows:
A.
Loosen the 3 bolts that fasten the Park/Neutral Switch (See Figure 2).
B.
Rotate the Park/Neutral switch as required to insert the 4 mm (5/32") dowel pin (see Figure 2).
C.
Tighten the 3 bolts that fasten the Park/Neutral Switch.
6.
Proceed to Part B and complete Part B - Adjust and Remove Play from the Transmission Control Cable.
Part B - Adjust and Remove Play from the Transmission Control Cable:
1.
Shift the transmission lever into Park (P) position.